I'm very interested in how you plan on fitting it in the Nova since I'll be going down that road myself at some point.
Specs? List of materials? I also noticed it looks like you're running coil packs. Interesting...
Dyno run yet?
The specs...
250 .040 over
Head was done by Mike Kirby @ Sissell with a setup for ARP studs in the lumps
Harland Sharp roller rockers with custom length Comp push rods
Ross racing pistons and 6" Scat h-beam rods
Cam is Comp grind for turbo
Holley Terminator EFI (HP EFI setup)
Holley DIS w/ 60-2 trigger wheel no cam sync
Holley 2 solenoid boost control
SPA turbo manifold w/ 522r .70 A/R turbo
Clifford intake
Aerospace Components electric water pump with two feeds, one to the water pump plate and the second to the block between cylinders 4 and 5.
The plan to fit it in the Nova may not be the same case as yours. I have a Heidts front clip so there shouldn't be any big issues(hopefully). The inside fender wall may come into play.
Yes, it has Holley's DIS setup, 60-2 trigger wheel no cam sync.
Haven't had it on the dyno. Just got it running last week late and I think the plan is to get it installed and chassis dyno.
