Here is the prototype. Also put this in the 12Bolt happenings, but nobody reads that. The start of a new intake manifold. Designed to fit the GM car platforms ( ChevyII, Camaro, Chevelle ect). Should improve TQ and HP. This is a full size 3D printed part. It will be prepped to bolt on and test. If all goes well, then made in a cast aluminum part. As is this weighs 3 lbs in plastic. Longer runners, smaller than other intake port entry to increase velocity and matched floor to meet up with a head lump. Dreamed up by 12Bolt Tom and Mark Mincey
Inliner Member 1716 65 Chevelle Wagon and 41 Hudson Pickup Information and parts www.12bolt.com
